Many friends have never understood how to determine the installation point of the wifi jammer. Today, the manufacturer of the mobile wifi signal jammer will explain and answer this question for you.
1. For single space
Like common small and medium-sized conference rooms, the interior is a transparent environment, and the selection of wifi blockers are relatively simple and requires fewer points.
2. 100-300 square meters
For a conference room with an area of about 100-300 square meters, generally installing 1-2 low-power units in it is basically enough to shield the entire conference room. The installation location is also arbitrary according to the site environment. If there is a ceiling or a movable ceiling above the conference room, the wifi jammer device can be directly installed in the ceiling or ceiling. Or you can choose to install it in a conference table, a corner or a wall in the venue. You can use the built-in omnidirectional antenna. If you want to reduce the impact on the outside world, you can replace the directional antenna.
3. Above 300 square meters
In a single space with an area of more than 300 square meters, the installation point of the wifi frequency jammer can be selected by the method of equidistant distribution according to the length and width of the site. The number is generally more than 3. For the installation location, if it can be installed on the ceiling in the middle, it can achieve the effect of complete coverage with fewer points. Otherwise, the installation method of hanging on the walls on both sides is adopted.
In order to facilitate the successful installation, the area of the installation site should be clarified before installing the wireless wifi bluetooth jammer. When installing, it must be determined according to its coverage, and cannot be installed at will. in order to improve its shielding effect. Promote signal attenuation and shielding.
